1PH230V-10HP COYOTE

10HP Coyotes protect against run-dry, over-current, low voltage, high voltage and rapid cycling. They trip in a fraction of a second upon sensing a lack of fluid and restart the pump at any interval dialed on the Timer from 1 minute to 12 hours.

Protection for single phase 230V pumps rated 1/3 to 10HP.

Sensitivity to run-dry is adjustable and set at installation by dialing a knob until an LED illuminates.

Voltage trips occur 2 seconds after bad power is detected and reset 1 minute after proper power is restored.

Overcurrent trip is a fraction of a second and Coyote will try twice one minute apart to restart the pump. If normal current is not achieved, the OVERLOAD light will blink and Coyote will not attempt to restart again so as not to burn out a motor winding.

Controls available inside the enclosure on the circuit board, or outside the enclosure so Coyote can be used with the enclosure lid in place.

The enclosure is rainproof.

1PH230V-PS COYOTE

PS Coyotes mount directly to the pressure switch. They offer the same run-dry and low voltage protection as Basic Coyotes. They trip in a fraction of a second upon sensing a lack of fluid and restart the pump at any interval dialed on the Timer from 1 minute to 60 minutes.

Sensitivity to run-dry is adjustable and set at installation by dialing a knob until an LED illuminates.

Available for 115V applications as well: Model 1PH115V-PS.

1PH230V-MINI COYOTE

Mini Coyotes protect against run-dry and low voltage. They trip in a fraction of a second upon sensing a lack of fluid and restart the pump at any interval dialed on the Timer from 1 minute to 5 hours.

To conserve space, wiring time and expense it slips neatly inside the control box of any 3-wire pump.

Restart time after proper voltage is restored is 4 seconds.

3PHALL COYOTE

Three phase coyotes offer protection for three phase pump applications against run-dry, over-current, bad power, phase reversal and rapid cycling. They trip in a fraction of a second upon sensing a lack of fluid and restart the pump at any interval dialed on the Timer from 1 minute to 12 hours.

Sensitivity to run-dry is adjustable and set at installation by dialing a knob until an LED illuminates.

• Models available to cover all of these applications:
• 208 Volts 1/3 to 60 HP
• 230 Volts 1/3 to 75 HP
• 380 Volts 1/3 to 125 HP
• 460 Volts 1/3 to 150 HP

Please have your application Voltage and Horsepower ratings when ordering.

Overcurrent trip is a fraction of a second and Coyote will try twice one minute apart to restart the pump. If normal current is not achieved, the OVERLOAD light will blink and Coyote will not attempt to restart again so as not to burn out a motor winding.

Voltage trips occur 2 seconds after bad power is detected and reset 1 minute after proper power is restored.

Panel mount Coyote shown here, more options below!

3PHALL-NEMA3R COYOTE

Our 3PHALL Coyote in a rainproof 12x12x6 NEMA3R rated steel enclosure. NEMA4X enclosures also available.

Please have your application Voltage and Horsepower ratings when ordering.

Controls available inside the enclosure on the circuit board, or outside the enclosure so Coyote can be used with the enclosure lid in place.

One inch RED or GREEN sentinel lamps available.

Power disconnect available.

3PHALL-MAG COYOTE

Our 3PHALL Coyote with a magnetic contactor in a rainproof 18x12x6 NEMA3R rated steel enclosure. NEMA4X enclosures also available. Model shown has contactor rated up to 20HP at 460V, more voltage and horsepower ratings available; please have your application Voltage and Horsepower when ordering.

Controls available inside the enclosure on the circuit board, or outside the enclosure so Coyote can be used with the enclosure lid in place.

HOA switch available (Hand Off Auto).

One inch RED or GREEN sentinel lamps available.

Power disconnect available.

PIPE HEATER

Coyote Pipe Heater is an effective and low-cost way to protect from freezing risers under mobile homes, freezeless hydrants that no longer drain properly, pressure switch nipples and other exposed pipes.

Watertight and never get too hot, they are safe to use with PVC and poly pipe as well as copper and steel

The 4″ OD by 2″ ID insulating tube traps warm air, lets it rise up the tube and protects to -25F, yet costs just pennies a day to operate.

Built tough for a long life, the 12″ heater with 6′ cord, 3′ tube and tube seam closures are all neatly packaged in a 4x4x36 sturdy cardboard box. Please specify 230V or 115V when ordering.

SURGE PROTECTOR

Coyote Surge Protectors protect against lightning induced power surges and voltage transients that are dangerous to equipment.

ANALOG METER

Analog Multimeter – Voltage, Ohms, Amps.

A must for pump work, it shows current changes instantly.

Digital meters are too slow to capture these events.