|
|
UNDERLOAD OR LACK OF FLUID
Coyote shuts off the pump within one second of running
dry, and automatically restarts the pump at any time you dial on the
timer from one minute to twelve hours.
trip
delay
reset
delay
1
second
adjustable
1
minute - 12 hours |
|
OVERLOAD
Coyote's microprocessor circuit memorizes the normal
running current of your pump's motor. If Coyote shuts down the pump
due to excessive current, it will restart it sixty seconds later. If
the motor draws normal current Coyote will allow it to run. If,
however, after two consecutive attempts one minute apart the motor
continues to draw excessive current, Coyote locks out the pump so as
not to burn out a motor winding and the overload light changes from
on steady to blinking.
trip amps
trip
delay
reset delay
150% of normal
1/4
second 60 seconds |
|
VOLTAGE FAULT
Plus or minus 2%
low
voltage high voltage
Model
trip
reset reset
trip
1PH115VSUPER
95V 100V
130V
135V
1PH230VSUPER
190V 200V
260V 270V
trip delay
reset
delay
2
seconds
60 seconds |
|
RANDOM START
When energizing Coyote by turning on power at circuit
breaker or fused disconnect there is a delay of 4 to 10 seconds
before Coyote turns on the pump. This "random start"
feature is designed to prevent many pumps served by a single power
source from all restarting at the same instant when power is restored
after a power outage. |
|
ALARM
If you wish to ring a bell, light a light, or activate
some other alarm, Coyote's normally open dry alarm contact closes on
any fault condition. |
|
|
HORSEPOWER RATING
1PH115VSUPER 1/3
- 1 HP
1PH230VSUPER 1/3
- 2 HP |
|
OPERATING RANGE
-20° to 70° C temperature
0% to 95% humidity noncondensing |
|
OVERALL DIMENSIONS
11 1/2"H x 6"W x 4"D
(including mounting tab at top) |
WWW.COYOTEMFG.COM |